Mind Monitor

Hi James,

I recently restarted a project and while checking the osc messages from mind monitor i noticed that the blink and jaw clench messages don't show up anymore. They remain in your documentation though.

I haven't seen any setting to turn them on/off either ..

Was this removed from a recent version? Could I revert to an older version with it?

There have been no changes to these. They're still working. I would check your code is looking for the correct data type. They're both single ints.

I'm just monitoring all messages sent by mind monitor and those addresses do know show up.

print: /muse/elements/touching_forehead 1
print: /muse/elements/alpha_absolute 0.274618
print: /muse/elements/beta_absolute 0.216085
print: /muse/elements/delta_absolute 0.634837
print: /muse/elements/theta_absolute 0.085246
print: /muse/elements/gamma_absolute -0.071282
print: /muse/elements/horseshoe 1. 1. 1. 1.

these are the only elements messages i am receiving.

You're missing a lot of stuff then. Check your filters. Everything listed in the spec is being sent.