Mind Monitor

I'm having severe connection issues with the Muse S. I cannot go any reasonable length of time without a BF flag or visible issues on the Raw screen. I've tried everything muse recommends. I've also tried electrode gel which I use for my hear rate monitor. Do others have the same issues? Are you able to just slip it on, move hair, and go? Right now it is taking me at least 20 minutes to get a good connection and even then I will still have BF flags during a 60 minute session. Are my hopes too high? Are others able to go 60 minutes without a BF? Do the original and Muse 2 have these issues? I'm considering returning but I really wanted it to work better than it did. Right now it is just taking too much time to set up.

Thanks!
Michael

I am having the same issue! <3

Same here

It can be an issue on headband (electrode or wire to connect electrode to connector), PIN issue on connector from the pod's (look if PIN didn't remain pressed).
After that, it can be also electrical interference (50Hz 220volts and/or 60Hz 110volts)